Resetting a Maytag Maxima Steam X Front Load WasherI have a Maytag Maxima steam x front load washer. In mid cycle it throws e01 and f08 codes, the door will not unlock and there is no power. Here is my tip. I kept unplugging the power cord and plugging it back in over and over for about 15 minutes, continuously. It finally unlocked and reset itself.
Check the Hoses on Your Washing MachineOur newer washing machine has been giving an error code and not getting the clothes clean at all. We searched the Internet and found that the code indicated low water level. We tried cleaning the detergent tray, and that seemed to help, but a week later, we were getting the same error code.
Check Valves Before Calling For Washer RepairMy Bendix washer recently made all the right noises, and lit up beautifully - but didn't fill with water. It suddenly occurred to me that there might be an airlock or sticking valve, so I picked up the inlet pipe, lifted it above the level of the inlet valve, and gave it a very gentle shake. Whatever the explanation was - my washing machine has been working perfectly ever since.
Clear Washing Machine Filter To Help DrainageMy washing mashine didn't spin the water out. In the morning, I opened the small door on the front of the machine, in the right down corner.
Repairing Motor Coupling in Kenmore Washing...If you have an older washing machine that stops spinning, the problem may be a cracked motor coupling. The replacement part runs about $15.00, but you can easily spend $150.00.
Avoid Fabric Softener in Your WasherNever use liquid fabric softener in your clothes washer! By doing so, you will cause yourself more service calls (repair costs!), and ultimately lessen the life expectancy of your washer. Fabric softener coats and clogs the hoses (and other parts, depending on the type of washer you have).
Cure for Slow Filling WasherCure for Slow Filling Washer. To save yourself the cost of a repairman, if your washer is filling slowly. Turn off the water at the valve, and take the hoses off and be sure that the connection is clean. When my washer was filling slowly, I did this and found that the hose was partially blocked by sediment.