I have an MTD lawn tractor, Diana t81. When I'm changing the drive speed in the 3rd, 4th, or 5th gear, it still drives slowly as if in the second gear? What could be the problem?
Try putting it in neutral, then in 6th gear, then letting out the clutch. I've read this re-aligns it.
Where is the gizmo on my 16.5 MTD riding mower (15 yrs old about) that will let me push it out of gear. It is stuck in a field and won't start up so. I need to push it. Thank you very much.
By Peter
My garden tractor blows the fuse only when I turn it off.
By Kent W
I have replaced the belts, but the tractor still will not move. Could it be the transmission?
By Tim B.
How do I adjust the belts so that my gears are all useable? I have a MTD.
By Elli from Nanango
My MTD riding mower keeps throwing the rear drive belt. It is a 14hp, 38 inch cut. It is fine on level ground, but seems to throw the belt on a decline or when turning on an uneven area. I replaced both drive belts in April and started having this problem in early June.
By Tom O.
How do I install a deck engagement cable on my MTD mower?
By seege
I have a Yard Machine MTD Special Edition, 18 HP Briggs and Stratton. I have installed a new battery, solenoid, and new battery cables. I checked all of the safety switches. When I try to start the engine with the key I get a chatter from the solenoid. I have started the engine by using a battery with jumping cables. What could be wrong?
By Bruce from Marion, IN
I have a MTD lawn tractor 600series, 42in. It suddenly stoped moving. The engine is still running and the deck is running fine, but the car won't move forward and backward. I checked the gear, it appears to be attached to transaxle just fine. I also checked on the R.H spring part and it appears to be fine. Can anyone help? Do you think the transaxle (part number 618-0163) is done? Thanks.
By pengteo from Redmond
Both bearings blew out on the double pulley above the deck on my 1996 MTD riding mower. Are they different sizes?
I have a 14.5 hp MTD yard machine and it is stuck in gear. How can I get it out of gear? Thanks.
How do I go about changing the front belt on a MTD task force riding lawn mower?
By sharon from Lecanto, FL
My MTD 15.5HP riding mower won't run unless the choke is pulled out. What could be the problem and how to fix it?
By Ron from Nashville, TN
Ron, I think your carburetor is dirty. Remove and clean it well. Billy Griffiths from South Africa.
I have an MTD riding mower, 18hp twin power. I have a carburetor issue, if I choke the carb and cover the little hole with my finger, the engine starts right up. If I remove my finger, it will die. I run the rider with choke pulled out fully. I am unable to utilize the throttle control or it will die. If I push in the choke just a little it will die, does anyone have an answer to my dilemma?
By Dano77 from Buckner, MO
I have an MTD 42a707 18.5 hp riding lawnmower. The engine turns over plenty fast, it is getting gas, and has new spark plugs, but is not getting a spark. Does that model have a coil?
By craig from Zimmerman, MN
If you're not starting and the plug is firing good, it's likely the "anti-backfire valve" has taken a dump. It screws into the bottom of the carb and has a couple of wires on a plug attached. Remove and replace.
Where can I find out how to install the rubber arm pads on my MTD yard machine? I am using replacement round arm pads, Wheeltronic Lift/Snapon Lift.
I wanted to give you the website address for this downloadable PDF file that tells yu how to install all parts on different model MTD mowers but when you click on the link it automatically download the PDF file. I think you can use this link to download the book that will tell you how to do this one manuals.mtdproducts.com/
I have a Yard Machine (MTD) from around 2003, that won't start. When I turn it over, it spins, but won't fire. I cleaned up the carburetor, changed the fuel and oil, and changed the spark plug, but it's still doing the same thing.
Any suggestions?There is a safety switch under the seat. Make sure it is not disabled.