I have an MTD lawn tractor, Diana t81. When I'm changing the drive speed in the 3rd, 4th, or 5th gear, it still drives slowly as if in the second gear? What could be the problem?
Try putting it in neutral, then in 6th gear, then letting out the clutch. I've read this re-aligns it.
I have an MTD 42a707 18.5 hp riding lawnmower. The engine turns over plenty fast, it is getting gas, and has new spark plugs, but is not getting a spark. Does that model have a coil?
By craig from Zimmerman, MN
If you're not starting and the plug is firing good, it's likely the "anti-backfire valve" has taken a dump. It screws into the bottom of the carb and has a couple of wires on a plug attached. Remove and replace.
My MTD 15.5HP riding mower won't run unless the choke is pulled out. What could be the problem and how to fix it?
By Ron from Nashville, TN
Ron, I think your carburetor is dirty. Remove and clean it well. Billy Griffiths from South Africa.
I have an MTD riding mower, 18hp twin power. I have a carburetor issue, if I choke the carb and cover the little hole with my finger, the engine starts right up. If I remove my finger, it will die. I run the rider with choke pulled out fully. I am unable to utilize the throttle control or it will die. If I push in the choke just a little it will die, does anyone have an answer to my dilemma?
By Dano77 from Buckner, MO
My MTD ride on lawn mower runs great, but quits when I let the clutch out. It is model 13ab662f516 13.5 HP in perfect, hardly ever used shape.
Thank you.
The engine starts with no problem, but begins to surge, RPMs up and down. Why?
You might need to clean its carbs
The drive pulley on my MTD riding lawn mower broke. I removed the bolt that holds it on. Do I have to have a "puller" to remove the pulley or just will power and a hammer?
I wouldn't think twice. Slap a puller on it.
If you are going to be fixing things like this you really should have a set of three-jaw pullers.
A pulley "puller" is a good idea. Harbor-Freight in Spokane on Sprague and Sullivan has them.
DoctorBill
Look for a product called, "Fluid Film" at hardware or farm store. It's based on lanolin/wool wax, and is the best stuff I've ever found for getting really difficult parts to release.
i have a 1994 mtd 18 horse lawn tractor. it has a 6 speed control, it's stuck in the third speed and can't start the engine.
My MTD mower rider will start with the drive belt off, but when I put the drive belt on it just jerks and will not turn over. I would really appreciate some help with this issue.
I have replaced the starter, replaced the battery, and checked for loose wires.My 14 hp. MTD riding lawn mower will only start with a charger attached at 75 amp jump start setting even with a new fully charged battery. How do I know if it is the solenoid or the starter?
I do hear a single click noise each time I turn the key. The starter is warm after trying a few times which lends me to believe it is the starter. Thanks for any suggestions.My right back tire is flat, I took off the screw, but can't pull off the tire. Is it supposed to come off from the front of the wheel? In other words are the things that look like washers just frozen because of rust? Or does it pull off from the back of the tire?
By Linda W. from Salt Lake City, UT
I have a John Deere but I believe removing the rear tire from your machine would be the same. The wheel is held on with a snap ring. You will need a special pair of pliers to remove the snap ring. You should be able to buy the pliers at an auto store. The ring looks like a washer except it has a piece cut out and two holes drilled into the washer near the opening.
I have a 18hp MTD mower that won't turn over. I've replace the starter switch, starter solenoid, and safety switch, as well as replaced the 7.5 amp fuse. Any ideas?
I usually try spraying a little carb cleaner in as I turn the key. You can try the fuel filter and make sure your gas is still good after sitting all winter.
I was having the same problem. It turns out that a piece of cord was wrapped so tightly around the blade shaft that it was frozen there. Cutting wet grass has jammed my blade also.
Have you checked your spark plug for carbon, that would be my next check, then the fuel filter to see if it's clogged.
I have a MTD l42 riding mower. When trying to crank, the solenoid keeps clicking when cranking.
I have 2007 42 inch Yard Machine riding mower. I forgot which hole my blade cable goes in on my deck.