Information on making recycled tire planters.
Materials
Directions
Draw pattern with chalk along side wall on one side of tire. Space scallops/ or ^^^ evenly around tire. Start at tread and end close to rim. Cut out with knife, using straight up and down motion, pointing blade away from yourself. This wil separate the tire into two pieces. Place your foot in center of rim and pull one scalloped edge toward yourself, this turns it inside out. Continue until it forms planter with pedestal. Fill with potting soil. Can spray paint planter to jazz it up.
Good luck, I am going to make mine this week.
By pikachu6
Penn State College of Agricultural Sciences has great insturctions for making a tire planter: "Finding the right tire is essential in making a tire planter. The tire you select should be well worn, and pliable in the shoulder area of the tire (what Felder calls the "sweet spot"), just below the tread. You can tell if the tire is a good candidate by pushing in on the shoulder area with the palm of your hand. If there is plenty of "give" in this area, the tire should be easy to work with. If not, you should find another one to use."
Type of tyreAdvertisement
The kind of tyre you use is important. An ordinary car tyre has steel belting so is near impossible to cut and will have sharp edges. I made Ron from old Vespa motor scooter tyres as they are easier to cut. If you could source some very old car tyres which are textile belted, they would be suitable, but still very hard to cut by hand.
To downlod the PDF go to Download PDF