We have a circuit breaker that all of a sudden keeps tripping. The breaker box goes directly to the power pole and the only thing on the problem circuit breaker is the pump for our well. We've had this pump on this breaker for 15 years and just started having a problem in the last few days. We already tried replacing the circuit breaker. We replaced it with a 15 amp breaker because that's what was in there before. That did nothing. Can anyone help please?
By Tim A
The breaker is tripping from overcurrent. If it trips immediately, it is most likely a short to ground. It could also be a locked rotor on your pump.
If it takes time to trip, it is an overcurrent, and for some reason the pump is working harder than it used to. Maybe buildup within the pump or bearing failure.
Look for physical damage of the cable feeding the pump from the breaker.
If none is found, have an electrician megger the leads to the motor to see if you have a short to ground.
If you do not, you may need to have someone pull the pump and have the motor tested and/or replaced. If it has been the same pump for 15 years, it may be at the end of its life.
I bought my house a year ago. The electrical box was replaced because it did not meet code as well as some wiring and new outlets were installed. I have had absolutely no issues, never blown a breaker or anything.
I came home tonight to find only some of my house working. Half the kitchen, half the living room, half the basement, and my garage door won't open. I checked the electrical box and a breaker blew. I reset it and switched it back on and all it does is spark a little and shut right back off. I unplugged eerything in my house and waited a few hours and tried again and still nothing.
I live in Illinois where we've had the worst winter ever, averaging 70 inches of snow over the course of winter. Today however it reached around 50 so everything was melting and water just pouring down my house non stop. I read there is a box outside as well. Could that be an issue? Or a bad breaker? Please help! The electrician wants $150/hr.
By Missy Mo
That electrician might be worth every cent of that $150 /hour. Since you have had no serious issues before, and have just had everything replace, this sounds like a serious issue to me.
My trailer house has a breaker box in my trailer for different parts of my trailer, but it keeps tripping the breaker box on the outside pole that my trailer is plugged into. If I have the dryer and AC on it trips. If I have the microwave and washer on it trips and I have to go outside to reset the switch. Help.
By tootiel from Menominee, MI
Those appliances are pulling to much power. You or the owner of the trailer park need an electrician to up the ampage to the outside pole or to the house.
I have a 7.5 Kw motor started by a control circuit with breaker. The breaker is tripping while I stop the motor. What is the cause for this?
By Linga
There's an electrical problem of some sort that could be dangerous, that's why the breaker is tripping. Have the motor checked soon.
I live in a three bedroom deluxe seven room plus basement altogether. So I just got my circuit breaker replaced because it was going out. The workers put in new one.
I keep small heaters on, but now that it's been replaced I can't use the microwave or my room, kid's room, parts of my mom's room, part dinning room, kitchen, and basement goes out. The guy who fixed it put it on 15amp. Should it be all on one like that?
By LW from Kansas City, MO
No, it should not. It might be a good idea to figure out what is all on that breaker. From my experience, a microwave takes a lot of power. Perhaps, in the short term, you can plug that microwave into a different outlet that is not on this circuit. I have too many outlets on one breaker, and I am going to have the electrician come in and add more circuits (put in more breakers). This may be what you need to do.
I just moved into a 1950s house. All the electric seemed to be working fine until carpet was installed yesterday. The circuit breaker flipped and flips again immediately after each attempt to turn it back on. There is no power being drawn on the circuit. It is only feeding overhead lights and outlets with nothing plugged in.
By Susan
If this started after carpet was installed, I'd say somewhere a wire got nicked. It is time to have an electrician come check it out.
I have an outside vapor light my husband installed on one end of our barn. The light is on a separate breaker with just the light and a plug on it. I have noticed the past few nights after it has been on about 6 hours the light goes out. When I went to check on it the next morning the breaker had tripped.
My husband had put another vapor light on the other end of our barn and it is fine; it also is on a separate breaker. We have a breaker box with about 20 breakers in it and so far none have tripped except the one.
By annie1 from Crosby, TX
Something is causing that breaker to trip-don't take the chance of a fire or electrocution, call a pro in to find out what is wrong.
The breaker to our living room and patio has tripped twice at night. Once my husband just flipped it back on and it was fine. The next night it happened again and will not flip back on. The things on the breaker are just standard things (TV, 2 lamps, an overhead light and fan, as well as, the overhead lights and fans on patio).
We can't figure out why it won't flip back on or why it is tripping at night when everything is off. Any ideas? Oh, and this is a new construction home. We have been in it 1 1/2 years.
By K.D.
Usually you will find it on the outside part of the things you mentioned. A bug or spider in the fixture. Turn the breaker off and clean all the fixtures outside including the plug ins. Moisture sometimes causes the wires to corrode, usually something simple like that if it hasn't been doing it before. I do my own and there is no risk as long as the breaker is off.
We have a 3 bedroom house and my son's family started living with us. Before this we were only using 1 bedroom. Now there is a 110 volt window unit in every room, AT&T U-verse TV in every room, plus naturally the lights. The breaker started tripping (15 amp) so we bought a new one. The new one is tripping now. Help! What to do? Can we go up to a 20 amp breaker?
By Carol
Do not put in a 20 amp breaker. Breakers are sized to protect the size of wire in a circuit. In general 15 amp breakers are used to protect 14 gauge wire, 20 amp 12 gauge. You most likely have 14 gauge wire and over sizing the breaker is dangerous and can lead to short circuits and fire. The answer is to use fewer appliances, especially a/c units or have more circuits put in, maybe even a dedicated line for each a/c unit.
My breaker keeps tripping. My air conditioner is on a 15 amp circuit and it goes out every 6-19 minutes, and then I will have to reset. It also takes out the living room, kitchen, and bathroom lights. This is in a one bedroom apartment. I have unplugged everything in the bedroom, bathroom, and kitchen except for the fridge, but it still goes out. What to do?
By Tameka
Actually contact your apartment manager and he should have maintenance check it out for you. Unless you own the apartment, instead of renting it is his responsibility.
I have girls and they keep tripping the 20 amp breaker. I made sure there is 12 gauge wire and there are only two receptacles on this circuit. But when the girls plug in both hair dryers and curling irons it blows the breaker. Will I have to run a dedicated line for each receptacle?
By Troy
A hairdryer is nominally rated 1500watts; according to the NEC, the breaker has to be rated at least 80% greater than the load. Hence, 1500w divided by 120vac = 12.5 amps x 125% = 15.63 Amps (minimum rating for the circuit breaker) Now if you have TWO hairdryers (12.5A x 2 = 25 Amps) on the one 20A circuit breaker, you'll trip every time. If you don't, then you really have problems.
You could run #10 Romex and change out to a 30A circuit breaker but that will put the breaker at maximum capacity. It may make more sense to leave the #12awg, change the circuit breaker to a 25amp rating and run an identical separate circuit of the same. Otherwise you will keep having issues.
We have a 15 amp breaker that keeps tripping. This is something that just started happening. This is what feeds off that breaker: livingroom lights, 2 TVs, kitchen lights, fridge, washer, dryer, master bedroom, guest bathroom, laundryroom lights, all porch lights, and a new gas heater with an electronic ignition and fan. This is a 1977 doublewide mobile home. What could suddenly cause this to happen and is it dangerous?
By Kim from Silver Springs, NV
You bet your bippy that's dangerous! Unplug everything and get an electrician out there today to help you sort out what is overloading that particular breaker. My guess is that whomever installed the new gas heater didn't 'add' a new breaker for it exclusively.
1) the circuit breaker has gone bad (they do that)
2) you have way, way too much on that breaker!
I would bet that the breaker trips when the heater comes on. The heater should be on its own breaker. I agree with everyone else, call the electrician now!
