I have a Frigidaire Gallery fridge. I have changed the water valve, filter, and the ice maker. It made only one round of ice and I can hear it trying to cycle, but no water goes into ice maker.
If you have already changed the necessary pieces for the ice maker and it is not adding water again then there could be a problem with the pump or the water lines being clogged. Normally the pump will pump the water needed and this is a good place to start.
My ice maker, model 106.9738612, will not fill with water. I have replaced both ice maker and valve, but it still will not fill up with water.
I used a jumper on the ice maker and the water filled up. There is good water pressure and the rest of the ice maker works.try replacing the thing that is sapossed to hold the water you can get them at a store
Kenmore ref.ice maker is not getting water I have check
I have an Amana fridge with a Whirlpool model number - ASD262RHRB. The ice maker is not filling with water. I replaced the whole ice maker and still no water.
The water out of the door works fine. What could be the issue?My ice maker is not getting a lot of water. I replaced the water inlet valve today, but still not a lot of water.
I have a Kenmore refrigerator and the ice maker is not filling with water.
Try going thru the trouble shoot guide that is the book that came with it. When was the last time you changed the filters?? Once when mine did this it was because the line had frozen.
I replaced the ice maker inlet valve and filter housing. I can hear the ice maker cycling, but it does not receive water. I have checked the water pressure from the wall and it runs well.
By Nancy M
Turn off, unplug and let it sit a bit and try it again. Ours does this every once in awhile. I don't know if water is freezing in the line or if it just needs to reset or what.
Clean out the water lines.
My Kenmore fridge has no water running into the ice maker. What's the problem?
By jason from IL
We had the same problem with the water dispenser and it was a blockage (frozen) in the water line. The repair man said there was nothing he could do, but suggested we turn off the refrigerator for a while and see if that fixed it. We turned it off for about an hour and then took a hair dryer and let it run on the water dispenser.
This could also be hard water that is clogging the lines if you don't have a water softener connected to your home for your water supply. Replacing tubes may be necessary.
I have Kenmore refrigerator, model #106.57453703. I have problem with the ice maker, first I saw a red led light on top of the bottom for On/Off which is blinking all the time followed by not getting any water in to try of ice maker.
What is the cause of it and which part is broken?Kenmore has a website that provides customer service-you can call the numbers below or check the Kenmore website for more information:
Contact Us
Kenmore Product Questions
1-888-KENMORE (1-888-536-6673)
Retail Customer Care
1-800-549-4505
www.kenmore.com/
i have a 2003 Kenmore side by side fridge. I recently moved and when I connected the fridge, the water freezes in the shute to go into the ice tray. I have defrosted the line and water comes back out, but gets frozen again.
Water no longer comes out of the dispenser as well. What could be the problem?My Samsung ice maker turns, but no water is getting to the ice trays?
By Kacie
Check the water pump, hoses, and if water is flowing to the ice maker. You should be able to disconnect a hose to see if the water inside is frozen or not.
The water line is frozen up at the top of the freezer.
By Don K
I had this happen eons ago. I just repeatedly saturated a washcloth from the hot water tap. and held it to the line. When it cools down, back to the faucet. It is a time consuming process and involves sliding the appliance away from the wall to get your hands on the line but it does work!
My KitchenAid side-by-side refrigerator, model KSCS25I ice maker does not make ice. After changing the water filter, I dumped all of the ice. The ice maker was still functioning and produced more ice. I dumped this ice as well to assure filter residue was eliminated. The ice maker ceased to function at this point. It appears no water is filling the ice trays. A red light located on panel where the ice maker on/off switch is located is blinking. Any suggestions? Is it a faulty switch?
By Ed O. from Cypress, TX
Yes, I do believe it may be a faulty valve/switch. I am having the same problem at this moment and I just checked the lines for calcification and found the line to be clear but no water was entering the ice water line from the switch/valve area. Check here: part for a possible valve solution. www.partselect.com/
Here is the video on installing the part as well :D Good luck!
www.partselect.com/
