social

Smoke Detector Problem?

Advertisement

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
December 31, 20100 found this helpful

You might try changing all batteries if you haven't already. Also check the breaker for the smoke detectors, make sure it isn't tripped if not turn breaker off and check all wires to that circuit be sure they are tight. We have the same type of system when we change the batteries when turn the breaker off and than change the batteries and then turn it back on it resets the system. If it is only one detector chirping the problem with be with that detector and not the whole system. Hope this helps!

 
Anonymous
March 19, 20180 found this helpful

Thank you, I will try that

 

Silver Post Medal for All Time! 255 Posts
January 1, 20110 found this helpful

All smoke/carbon alarms are designed to only last for 10 years, after 10 years or after a fire, they need to be replaced with new ones. If you burn a fireplace, they need to be changed out more often.

Advertisement

Sounds like the sensor is going out, and when the HVAC system comes on, it creates enough air current to remove dust or debris on it.

I am a fire fighter, and one of our biggest issues is people think they are good for a lifetime. They aren't.

 
February 2, 20110 found this helpful

It's 4: 30am. I've been up since 2am with my smoke alarm going off constantly! We tried everything and my frustrated hubby went back to bed and covered his head to block out the sound! Even the dog wanted out and continued her blissful sleep outside!

Unfortunately, I couldn't sleep with that loud noise for the next hour or so, climbed up on a kitchen stool every 20mins to press the button to shut it off. It would stay quiet for about 20mins and then back on again. In the meantime, I decided to see if I could get some online help and found this site.

Advertisement

Thanks for all the tips. I was surprised but gratified to find others have experienced this too and what would you know? Most of the problems were at night. Murphy's Law! Then to annoy me further, the TV started an alarm test!

Anyway, I didn't have a can of air handy, (which I will now get) so I opened the windows for a bit and tried some of the other suggestions until on one of my trips back from the detector to bed, I noticed the thermostat battery in the living room was low so the heat was not on in that part of the house. I changed the battery and voila! silence!! I've waited 30 minutes and no more alarm so I guess I can sleep now, for all of 2 hours before have to be up.

Thanks everyone for all the helpful tips when my 'support system' here bailed out on me!

 
February 12, 20110 found this helpful

When smoke alarm batteries die they start chirping in the middle of the night when the temp in the house drops. I googled smoke alarms to find out why mine has space for two 9v batteries.

Advertisement

I think it may be because it has a lite in it, but not sure. Anyway that's how I found out about the middle of the night chirping!

 
Anonymous
November 28, 20150 found this helpful

Not chirping the actual fire alarm

 
July 10, 20110 found this helpful

Oh dear... I tried to check the circuit breaker and did a test on it. Well, I now have disconnected ALL the alarms in the house. Prior to this only two were chirping. They are still chirping but there is no green light on. I will try to remove and replace those new batteries. (The old were still good.) It seems I have made matters worse. I have had my system about 4 years. Any help would be appreciated. Thank you.

 
April 14, 20180 found this helpful

You need to disconnect the hard wire and remove the battery. Now hold the test button down for 15 to 20 seconds.

Advertisement

The stored power should now drain from the unit. Put it all back together and your chirping should stop.

 
November 1, 20141 found this helpful

I recently spent two nights of miserable insanity dealing with the malfunctioning/unreasonable/unstoppable shrieking fire/carbon monoxide detector issue, and even if your problem ceased after replacing the battery you should know a few important things about these supposedly life-saving devices.

First of all, if you take a sledgehammer to the device in question, it may or may not cease its infernal noise and you will have to pay for the inevitable damage to the wall or ceiling in addition to replacing the device. Living in subsidized housing has come to mean numerous rules and regulations of varying stupidity from a safety standpoint, since many "safety"measures are merely a matter of removing access or control from the tenant-locking the water heater closet and denying the tenants a key, a prohibition on giving the operation/care manuals to the appliances and devices installed in the residence are just two that have caused more problems than they prevent - and as offensive as these measures are to a person of reasonable intelligence like myself, many of my neighbors are perfect examples of the stupidity that has made such measures attractive to landlords from a financial point of view. It caused me great anger and outrage to find out that the apt manager could easily have stopped the insanity after the first night, but was prohibited from doing so by either CA regulations or ConAm Management Co policy, and at this point I don't care which.

Advertisement

The alarm system that is directly connected to and sends a signal to both the fire dept and Bay Alarm Co functions perfectly and is inspected and maintained on a bi-yearly basis and conscientious care.
The piece-of-**** secondary system consists of three smoke/CO detectors that have periodically malfunctioned since they were installed less than three years ago, when the complex was built, but never to the extent of this past week.

The offending devices have now been removed pending replacement, which I am going to be charged for. And I didn't even get the pleasure of smashing them with a sledgehammer as I oh so very much desired.
If you are a smoker, the nicotine residue causes dirt and sand (I live in the desert) to stick to the sensors. I understand this concept, yet wonder how it is that in the four decades that I have been a smoker, far heavier than currently, this has never happened. But that's a personal issue I will battle out with the landlord.

The important thing is to be aware that the devices manufactured since 2011 (I'm going by the date on the devices) are susceptible to things like dust, nicotine, grease from cooking, animal dander, and anything that can float through the air and collect on a surface anywhere, and that no consideration was given this inevitable process of life when making them. For some forms of dust, etc, canned air will blow the residue away or a vacuum will suck it out. That's if you are aware that more is necessary than simply using the vacuum attachment while doing spring or fall cleaning-you have to take it down and clean it somehow, not easy if you are handicapped and cannot steady yourself on a ladder or if you simply don't have a way to reach it safely. But if you don't do it twice a year, don't expect it to work when you need it to, according to the gentleman who maintains the REAL alarm system, and he won't touch the devices not part of his system, and the look of derision he gave them spoke volumes.

So I have read and researched and gotten opinions from professionals, including firefighters. Ionization type detectors should be replaced with photoelectronic ones, as the ionization ones tend to ignore the thick deadly smoke most commonly the cause of death in house fires until far too late. Use a vacuum or preferably compressed air to clean your devices at least twice each year. Replace the batteries, even in hardwired versions, once a year on a specific date-the fall when clocks are set back is best and easiest, you have that extra hour, after all, and with Christmas and lights made of cheap wiring around the corner, it's a good idea to know your batteries are fresh.

DO NOT simply unplug it or remove the battery if it's driving you nuts, then put off reconnecting or replacing it-follow through! Clean it, replace it, or whatever is necessary, and give the old one a good whack with a hammer for me before you throw it out. And the reason it goes off at night, I have been informed, is due to condensation that naturally occurs during that time of day. Be safe!

 

Bronze Feedback Medal for All Time! 135 Feedbacks
November 1, 20140 found this helpful

Thanks Elaine, for your wonderful sense of humor and good advice!

 
November 28, 20150 found this helpful

Every night between midnight and 3:30 3, 5 second actual fire alarms ALL THE TIME one night it keep going not chirping the fire alarm for hours and we called the non emergency line and they sent firemen they said look up at the lights for a green then red constantly not the 45 second red that's normal then replace the whole fire alarm not just batteries later we had the same problem with the same unit in the same place so we thought bad wiring ( we are hard wired) a guy came and "fixed it" we now have a theory that hot air could be doing it ? Replys would be nice

 
Anonymous
March 3, 20160 found this helpful

My smoke detectors all have red lights and new batteries but will not go off when I push the buttons.

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
In This Page
< Previous
Categories
Home and Garden Home Improvement Home SafetyDecember 31, 2010
Pages
More
🌻
Gardening
🐰
Easter Ideas!
👒
Mother's Day Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-03-28 01:35:46 in 2 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/Smoke-Detector-Problem.html