This pin is a recycle pattern with a Christmas theme. It is a tiny angel lapel pin using gold safety pins, pearls, and beads. It is appropriate for casual wear or for dressy occasions to Christmas parties.
Advertisement
Supplies:
gold or silver safety pins
pearls and gold or silver beads
beads
beading wire - 32 gauge
pin back
hot glue gun and glue
Instructions:
Start by threading 5 pearls (2 1/2 mm) onto each safety pin. Use the photos as a guide as you work.
Cut one piece of beading wire 6 or 7 inches long and string the head ends of the pins on this wire adding a 5mm pearl between each safety pin.
Then take the wire on each side, and thread it back through to the center pin.
Snug the pins up on the wire; then twist the wire at the back and clip.
Cut another piece of wire about 12 inches long and thread all 6 of the backs of the safety pins onto the wire.
Center them on the wire, and then add the 7mm pearl (bodice) by threading the ends of the wire through the bead from opposite sides.
Next, thread 7 gold or silver beads onto each end of the wire and thread the wire back through the 7mm pearl. Pull up until the wings form.
Advertisement
Continue with the same wire and thread both ends up through the 8mm pearl (head).
Thread 6 gold or silver beads for the halo on one end of the wire; then thread them on the other wire in the opposite direction.
Snug everything down until it is fairly tight with the head resting on the bodice and the halo standing on edge on the top of the head.
Run the ends of the wire down through the 8mm bead, then twist them together, and clip them.
Turn pin over and hot glue the pin back in position. See last picture for placement.
Click Here to download the instructions in PDF format.
This pin is a recycle pattern with a Christmas theme. It is a tiny angel lapel pin using gold safety pins, pearls, and beads. It is appropriate for casual wear or for dressy occasions to Christmas parties.
